Page 460 - Catalogue-Osawa-2021

HF HARD - Unequal pitch - Corner radius

CUTTING PARAMETERS
INFO
HF852

Material Group P4 M3 K4 P4 P5 P8 M3 K4 S1 P5 P8 P8 K4 S2 S3 H1 H4 H5
ISO 513
Hardness/Rm 800÷1000 N/mm² 900÷1200 N/mm² 35÷45 HRC ≤55 HRC
ap x ae 1.5D x 0.1D 1.5D x 0.1D D x 0.1D D x 0.1D
Vc (m/min) 130÷150 100÷120 60÷80 50÷70
CARBIDE D fz fz fz fz
DRILLS
(mm) (mm/z) (mm/z) (mm/z) (mm/z)
3 0.027 0.024 0.021 0.029
PU-HPU
TA-4HTA TROCHOIDAL 4 0.035 0.032 0.028 0.039
5 0.044 0.040 0.035 0.048
SUH
ALH 6 0.052 0.046 0.041 0.057
HRC 8 0.067 0.060 0.054 0.074
SUH MINI 10 0.080 0.072 0.064 0.088
HL 12 0.092 0.083 0.073 0.101
HSD 14 0.103 0.093 0.083 0.114
C-SD-TA 16 0.115 0.103 0.092 0.126
20 0.140 0.126 0.112 0.154

NOTES:
Down milling CNC programming is required.
“ae” value max 0.2xD - “T” value max 0.1xD.
The use of end mill with diameter 30-40% smaller than the width of the slot is recommended.
The cutting conditions are based on CNC programming with medium dynamic speed.
With lower CNC dynamic speed, use the same cutting conditions or reduce the cutting speed Vc.
With higher CNC dynamic speed, reduce the “T” value by approximately -30 -50% and apply the maximum available cutting speed Vc.
HSS R1 Cutter radius
DRILLS ae
R2 Half of slot width
T Programming width of cut
LFTA
SUTA R2 ae Actual width of cut
HSS-HSS/CO R1

Y (+)
Y

X (+)
T
CARBIDE
END-MILLS
G2
MDTA
HF VH/UP
MEF
ALU
MEX/MH
UH/MH

HSS
END-MILLS

CARBIDE
BURRS

PARAMETERS SUGGESTED WITH HIGH POWER MILLING CHUCK AND STABLE MACHINING CONDITION
458

21/10/2021 12:15:28
Libro 1.indb 458
Libro 1.indb 458 21/10/2021 12:15:28