Page 423 - Catalogue-Osawa-2021

HF UNI - Variable Helix and unequal pitch - Corner radius

CUTTING PARAMETERS
INFO
HF942

Material Group P1 P2 P7 K1 P3 P4 M1 K2 K3 P5 M2 M3 K4 S1 S4 S2 S3 S5
ISO 513
Hardness/Rm ≤700 N/mm² 600÷1000 N/mm² ≤35 HRC ≤40 HRC
ap x ae 2D x 0.1D 2D x 0.1D 1.5D x 0.1D 1.5D x 0.1D
Vc (m/min) 140÷160 100÷120 70÷90 40÷60
CARBIDE
D fz fz fz fz
(mm) (mm/z) (mm/z) (mm/z) (mm/z) DRILLS
TROCHOIDAL 4 0.034 0.031 0.027 0.037
PU-HPU
5 0.044 0.040 0.035 0.048
TA-4HTA
6 0.054 0.049 0.043 0.059
SUH
8 0.064 0.058 0.051 0.070 ALH
10 0.076 0.068 0.061 0.084 HRC
12 0.086 0.077 0.069 0.095 SUH MINI
16 0.098 0.088 0.078 0.108 HL
20 0.132 0.119 0.106 0.145 HSD
C-SD-TA
ap x ae ≤ D5 1.5D x 0.1D 1.5D x 0.1D 1.2D x 0.05D 1.2D x 0.05D
NOTES:
Down milling CNC programming is required.
“ae” value max 0.2xD - “T” value max 0.1xD.
The use of end mill with diameter 30-40% smaller than the width of the slot is recommended.
The cutting conditions are based on CNC programming with medium dynamic speed.
With lower CNC dynamic speed, use the same cutting conditions or reduce the cutting speed Vc.
With higher CNC dynamic speed, reduce the “T” value by approximately -30 -50% and apply the maximum available cutting speed Vc.
R1 Cutter radius HSS
ae
R2 Half of slot width DRILLS
T Programming width of cut

R2 ae Actual width of cut LFTA
SUTA
R1
HSS-HSS/CO

Y (+)
Y

X (+)
T
CARBIDE
END-MILLS
G2
MDTA
HF VH/UP
MEF
ALU
MEX/MH
UH/MH

HSS
END-MILLS

CARBIDE
BURRS

PARAMETERS SUGGESTED WITH HIGH POWER MILLING CHUCK AND STABLE MACHINING CONDITION
421

Libro 1.indb 421 21/10/2021 12:14:33
Libro 1.indb 421
21/10/2021 12:14:33